Honda 2004 Odyssey Service Manual page 2391

SRS
DTC Troubleshooting (cont'd)
'03-04 Models
DTC 92-1x (92-10 to 92-19, 92-1A to 92-1F):
Open in Passenger Airbag Cutoff Indicator
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the passenger airbag cutof f indicator stay
on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Check the connection between the dashboard wire
harness A 4P connector and the passenger's airbag
cutoff indicator.
4. Erase the DTC memory.
5. Read the DTC (see page 23-38).
Is DT C 92-1x indicated?
YES Go to step 6.
NO The system is OK; if DTC 92-1x is still present,
go to step 6.
6. Check the No. 9 (10A) fuse in the driver's
under-dash fuse/relay box.
Is the f use OK ?
YES Go to step 7.
NO Replace the fuse, then turn the ignition switch
ON (II). If the fuse blows again, check for a short in
the No. 9 (10A) fuse circuit (dashboard wire
harness A).
23-326
7. Disconnect the dashboard wire harness A 4P
connector from the passenger's airbag cutoff
indicator.
8. Turn the ignition switch ON (II).
9. Check for voltage between the No. 1 terminal of the
dashboard wire harness A 4P connector and body
ground. There should be battery voltage.
DASHBOARD WIRE HARNESS A 4P CONNECTOR
YEL
Wire side of female terminals
Is there battery voltage?
YES Go to step 10.
NO Open in dashboard wire harness A; replace
dashboard wire harness A.
10. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
A