Driver's Seat Position Sensor Replacement - Honda 2004 Odyssey Service Manual

SRS

Driver's Seat Position Sensor Replacement

Removal ('03-04 Models)
NOTE:
• Removal of the driver's seat position sensor must be
performed according to the precautions/procedures.
• Before disconnecting the driver's seat position sensor
2P connector, disconnect the driver's airbag 4P
connector.
• Do not turn the ignition switch ON (II), and do not
connect the battery cable while replacing the driver's
seat position sensor.
1. Disconnect the battery negative cable, and wait at
least 3 minutes before beginning work.
2. Remove the driver's seat assembly (see page 20-
81).
3. Disconnect the driver's seat wire harness 2P
connector (with power seat), or the driver's seat
position sensor subharness 2P connector (without
power seat) from the driver's seat position sensor
(A).
4. Remove the Torx bolt (B) using a Torx T30 bit, then
remove the driver's seat position sensor.
23-392
Installation ('03-04 Models)
NOTE:
• Be sure to install the harness wires so they are not
pinched or interfering with other parts.
• Do not turn the ignition switch ON (II), and do not
connect the battery cable while replacing the driver's
seat position sensor.
• After installing the driver's seat position sensor,
make sure it is clean. Keep it away from dust.
1. Install the new driver's seat position sensor with a
new Torx bolt (A) then connect the driver's seat
wire harness 2P connector (with power seat), or the
driver's seat position sensor subharness 2P
connector (without power seat) to the driver's seat
position sensor (B).
A
2. Install the driver's seat assembly (see page 20-81).
B
3. Reconnect the battery negative cable.
4. After the driver's seat position sensor has been
installed, check its operation with the HDS (see
page 23-47).
B
A
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)