Honda 2004 Odyssey Service Manual page 2449

SRS
SRS Unit Replacement (cont'd)
Removal ('03-04 Models)
1. Disconnect the battery negative cable, and wait at
least 3 minutes before beginning work.
2. Disconnect both seat belt tensioner connectors (see
step 5 on page 23-34).
3. Remove the center lower pocket (see page 20-67).
4. Pull down the carpet, then remove the Torx bolt (A)
from the SRS unit.
5. Disconnect the connectors and remove the two
Torx bolts (A), then pull out the SRS unit from the
right side.
A
23-384
Installation ('03-04 Models)
1. Install the new SRS unit (A) with Torx bolts (B), then
connect the connectors (C) to the SRS unit; push it
into position until it clicks.
NOTE: When tightening the Torx bolts to the
specified torque after replacement, be careful to
turn them in so that their heads rest squarely on the
brackets.
A
2. Reinstall the dashboard center lower pocket (see
A
page 20-67).
3. Reconnect both seat belt tensioner connectors (see
step 5 on page 23-34).
4. Reconnect the battery negative cable.
5. Initialize the OPDS unit (see page 23-41).
6. After installing the SRS unit, confirm proper system
operation: Turn the ignition switch ON (II); the SRS
indicator should come on for about 6 seconds and
then go off.
B
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
C