Honda 2004 Odyssey Service Manual page 2408

26. Connect the No. 3 terminal and the No. 6 terminal
of the SRS main harness 18P connector with a
jumper wire.
SRS MAIN HARNESS 18P CONNECTOR
JUMPER WIRE
Wire side of female terminals
27. Turn the ignition switch ON (II).
28. Check the SRS indicator.
Does the SRS indicator go of f ?
YES Faulty SRS unit; replace the SRS unit.
NO Go to step 29.
29. Turn the ignition switch OFF.
30. Disconnect the jumper wire between the No. 3
terminal and the No. 6 terminal of the SRS main
harness 18P connector.
31. Check the No. 2 (10A) fuse in the driver's under-
dash fuse/relay box.
Is the f use OK ?
YES Go to step 35.
NO Go to step 32.
32. Replace the No. 2 (10A) fuse in the driver's under-
dash fuse/relay box.
33. Disconnect the gauge assembly connector C (16P)
from the gauge assembly.
34. Check resistance between the No. 6 terminal of
SRS main harness 18P connector and body ground.
There should be an open circuit, or at least 1 M .
SRS MAIN HARNESS 18P CONNECTOR
Wire side of female terminals
Is the resistance as specif ied?
YES Faulty SRS indicator circuit in the gauge
assembly; replace the gauge assembly.
NO Short to ground in the SRS main harness or in
the dashboard wire harness; replace the faulty
harness.
C
(cont'd)
23-343