Honda 2004 Odyssey Service Manual page 2422

31. Connect the No. 3 terminal of SRS unit connector A
(18P) and the No. 5 terminal of the SRS unit
connector C (8P) with a jumper wire.
SRS UNIT CONNECTOR C (8P)
Wire side of female terminals
JUMPER
WIRE
SRS UNIT CONNECTOR A (18P)
Wire side of female terminals
32. Turn the ignition switch ON (II).
33. Check the SRS indicator.
Does the SRS indicator go of f ?
YES Faulty SRS unit; replace the SRS unit (see
page 23-382).
NO Go to step 34.
34. Turn the ignition switch OFF.
35. Disconnect the jumper wire between the No. 3
terminal of SRS unit 18P connector A (18P) and the
No. 5 terminal of the SRS unit connector C (8P).
36. Check the No. 2 (10A) fuse in the under-dash
fuse/relay box.
Is the f use OK ?
YES Go to step 40.
NO Go to step 37.
37. Replace the No. 2 (10A) fuse in the under-dash fuse
/relay box.
38. Remove the gauge assembly (see page 22-100),
then disconnect gauge assembly connector C (16P)
from the gauge assembly.
39. Check resistance between the No. 5 terminal of
SRS unit connector C (8P) and body ground. There
should be an open circuit, or at least 1 M .
SRS UNIT CONNECTOR C (8P)
Wire side of female terminals
Is the resistance as specif ied?
YES Faulty SRS indicator circuit in the gauge
assembly; replace the gauge assembly.
NO Go to step 45.
C
(cont'd)
23-357