Side Impact Sensor Replacement - Honda 2004 Odyssey Service Manual

Side Impact Sensor Replacement

Removal ('02 Model)
NOTE:
• Removal of the side impact sensor must be
performed according to the precautions/procedures.
• Before disconnecting the side impact sensor 2P
connector(s), disconnect the side airbag 2P
connector(s).
• Do not turn the ignition switch ON (II), and do not
connect the battery cable while replacing the side
impact sensor.
1. Disconnect the negative battery cable, and wait at
least 3 minutes before beginning work.
2. Remove the seat assembly (see page 20-81).
3. Remove the center pillar lower trim panel (see page
20-58).
4. Disconnect the side wire harness 2P connector (A)
from the side impact sensor (B).
B
C
A
5. Remove the Torx bolt (C) using a Torx T30 bit, then
remove the side impact sensor.
Installation ('02 Model)
NOTE:
• Be sure to install the harness wires so they are not
pinched or interfering with other parts.
• Do not turn the ignition switch ON (II), and do not
connect the battery cable while replacing the side
impact sensor.
1. Install the new side impact sensor with a new Torx
bolt (A) then connect the side wire harness 2P
connector (B) to the side impact sensor (C).
C
A
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
2. Reconnect the battery negative cable.
3. After installing the side impact sensor, confirm
proper system operation: Turn the ignition switch
ON (II): the SRS indicator should come on for about
6 seconds and then go off.
B
23-385