Honda 2004 Odyssey Service Manual page 2448

Installation ('99-01 Models)
1. Install the new SRS unit (A) with new Torx bolts (B),
then connect the SRS main harness 18P connector
(C) to the SRS unit; push it into position until it
clicks.
NOTE: When tightening the Torx bolts to the
specified torque after replacement, be careful to
turn them in so that their heads rest squarely on the
brackets.
C
2. Reinstall the center lower pocket (see page 20-67).
3. Reconnect the airbag connectors (see page 23-29),
and seat belt tensioner connectors (see page 23-29).
4. Reconnect the battery negative cable.
5. After installing the SRS unit, confirm proper system
operation. Turn the ignition switch ON (II); the SRS
indicator should come on for about 6 seconds and
then go off.
A
B
9.8 N·m (1.0 kgf·m,
7.2 lbf·ft)
Installation ('02 Model)
1. Install the new SRS unit (A) with Torx bolts (B), then
connect the connectors (C) to the SRS unit; push it
into position until it clicks.
NOTE: When tightening the Torx bolts to the
specified torque after replacement, be careful to
turn them in so that their heads rest squarely on the
brackets.
B
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
A
2. Reinstall the dashboard center lower pocket (see
page 20-67).
3. Reconnect the driver's and front passenger's airbag
connectors (see page 23-30).
4. Reconnect the side airbag connectors (see page 23-
31).
5. Reconnect both seat belt tensioner connectors (see
page 23-31).
6. Reconnect the battery negative cable.
7. Initialize the OPDS unit (see page 23-40).
8. After installing the SRS unit, confirm proper system
operation: Turn the ignition switch ON (II); the SRS
indicator should come on for about 6 seconds and
then go off.
C
(cont'd)
23-383