Side Airbag Replacement - Honda 2004 Odyssey Service Manual

Hide thumbs Also See for 2004 Odyssey:

Table of Contents

Side Airbag Replacement

'02-04 Models

NOTE: Review the seat replacement procedure (see

page 20-81) before performing repair or service.

1. Disconnect the battery negative cable, and wait at

least 3 minutes before beginning work.

2. Disconnect the side airbag harness 2P

connector (A).

3. Remove the seat assembly (see page 20-81) and

seat-back cover (see page 20-102).

4. Remove the mounting nuts (A) and the side

Installation

• If the side airbag lid is secured by a tape, remove the

• Do not open the lid of the side airbag cover.

• Use new mounting nuts tightened to the specified

• Make sure that the seat-back cover is installed

properly. Improper installation may prevent proper

• Be sure to install the harness wires so they are not

pinched or interfering with other parts.

1. Place the new side airbag on the seat-back frame

(A). Tighten the side airbag mounting nuts (B).

2. Install the seat-back cover (see page 20-102).

3. Install the seat assembly (see page 20-81), then

connect the side airbag harness 2P connector.

4. Move the front seat and the seat-back through their

full ranges of movement, making sure the harness

wires are not pinched or interfering with other parts.

5. Reconnect the battery negative cable.

6. After installing the side airbag, confirm proper

system operation: Turn the ignition switch ON (II);

the SRS indicator should come on for about 6

seconds and then go off.

Table of Contents