Table of Contents
Advertisement
SRS
Cable Reel Replacement (cont'd)
8. Install the steering wheel nut (A) and tighten it to
49 N·m (5.0 kgf·m, 36 lbf·ft).
A
B
9. Connect the radio remote switch connectors (B),
and cruise control switch connector (C).
10. Install the driver's airbag (see step 1 on page 23-
369).
11. Reconnect the battery negative cable.
12. After installing the cable reel, confirm proper
system operation:
• Turn the ignition switch ON (II); the SRS indicator
should come on for about 6 seconds and then go
off.
• After the SRS indicator has turned off, turn the
steering wheel fully left and right to confirm the
SRS indicator does not come on.
13. Check the horn, radio remote switch, cruise control
set/resume switch, and turn signal cancel for
proper operation.
23-380
Installation ('02-04 Models)
1. Before installing the steering wheel, align the front
C
2. If not already done, disconnect the battery negative
3. Set the cancel sleeve (A) so that the projections (B)
4. Carefully install the cable reel (A) on the steering
wheels straight ahead.
cable, and wait at least 3 minutes.
are aligned vertically.
A
column shaft. Then connect the SRS main harness
4P connectors (B) to the cable reel connectors (C).
C
B
C
B
A
Advertisement
Chapters
Table of Contents
Troubleshooting
