Honda 2004 Odyssey Service Manual page 2434

Installation ('99-01 Models)
1. Reconnect the horn connectors (A), then place the
new driver's airbag (B) in the steering wheel, and
secure it with new Torx bolts (C). Install the covers
(D).
D
2. Connect the cable reel 2P connector (A) to the
driver's airbag 2P connector (B), then install the
access panel (C) on the steering wheel.
B
3. Connect the battery negative cable.
4. After installing the airbag, confirm proper system
operation:
• Turn the ignition switch ON (II); the SRS indicator
should come on for about 6 seconds and then go
off.
• Make sure the horn button works.
D
B
A
C
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
A
C
Installation ('02-04 Models)
1. Place the new driver's airbag (A) in the steering
wheel, and secure it with new Torx bolts (B).
2. Connect the cable reel 4P connector (A) to the
driver's airbag 4P connector (B), then install the
access panel (C) on the steering wheel.
B
3. Connect the battery negative cable.
4. After installing the airbag, confirm proper system
operation:
• Turn the ignition switch ON (II); the SRS indicator
should come on for about 6 seconds and then go
off.
• Make sure the horn button works.
A
B
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
A
C
23-369