Front Impact Sensor Replacement - Honda 2004 Odyssey Service Manual

SRS

Front Impact Sensor Replacement

Removal ('02 Model)
NOTE:
• Removal of the front impact sensor must be
performed according to the precautions/procedures.
• Before disconnecting the front impact sensor 2P
connector(s), disconnect the driver's and front
passenger's airbag 4P connectors, and both seat belt
tensioner 2P connector(s).
• Do not turn the ignition switch ON (II), and do not
connect the battery cable while replacing the front
impact sensor.
1. Disconnect the battery negative cable, and wait at
least 3 minutes before beginning work.
2. Remove the front bumper (see page 20-128).
3. Disconnect the side wire harness 2P connector (A),
and remove the two Torx bolts (B) using a Torx T30
bit, then remove the front impact sensor (C).
C
23-388
Installation ('02 Model)
NOTE:
• Be sure to install the harness wires so they are not
pinched or interfering with other parts.
• Do not turn the ignition switch ON (II), and do not
connect the battery cable while replacing the front
impact sensor.
1. Install the new front impact sensor with new Torx
bolts (A), then connect the engine compartment
wire harness 2P connector (B) to the front impact
sensor (C).
C
A
2. Reconnect the battery negative cable.
3. After installing the front impact sensor, confirm
proper system operation: Turn the ignition switch
ON (II): the SRS indicator should come on for about
B
6 seconds and then go off.
B
A
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)