5. Install the steering column covers.
6. If necessary, center the cable reel. (New
replacement cable reels come centered.) Do this by
first rotating the cable reel clockwise until it stops.
Then rotate it counterclockwise (about 2 1/2 turns)
until the arrow mark on the cable reel label points
straight up.
7. Align the projections on the cable reel with the
holes on the steering wheel, and install the steering
wheel with a new steering wheel bolt (A).
C
A
38 N·m
(3.9 kgf·m, 28 lbf·ft)
8. Reconnect the cruise control set/resume switch (B),
radio remote switch (C), and the horn switch (D).
9. Install the driver's airbag (see page 23-369).
10. Reconnect the battery negative cable.
11. After installing the cable reel, confirm proper
12. Check the horn, radio remote switch, cruise control
D
B
system operation:
• Turn the ignition switch ON (II); the SRS indicator
should come on for about 6 seconds and then go
off.
• After the SRS indicator has turned off, turn the
steering wheel fully left and right to confirm the
SRS indicator does not come on.
• Make sure the horn button works.
set/resume switch, and turn signal cancel for
proper operation.
23-381