Honda 2004 Odyssey Service Manual page 2456

Front Passenger's Weight Sensor Unit Replacement
NOTE: Review the seat cover replacement procedure
(see page 20-102) before performing repair or service.
Removal ('03-04 Models)
1. Disconnect the battery negative cable, and wait at
least 3 minutes before beginning work.
2. Disconnect the front passenger's airbag 4P
connector (see step 3 on page 23-33).
3. Remove the seat assembly (see page 20-81) and
seat riser (see page 20-99).
4. Disconnect the connectors. Remove the mounting
nuts (A) and the front passenger's weight sensors
unit (B) from the seat riser.
Installation ('03-04 Models)
NOTE: Be sure to install the harness wires so they are
not pinched or interfering with other parts.
1. Place the new front passenger's weight sensors
unit on the seat riser. Tighten the two mounting
nuts (A) and connect the connectors to the front
passenger's weight sensors unit.
B
2. Install the seat riser (see page 20-99) and the seat
assembly (see page 20-81).
A
3. Reconnect the front passenger's airbag 4P
connector (see step 3 on page 23-33).
4. Reconnect the battery negative cable.
5. Calibrate the front passenger's weight sensors unit
(see page 23-42).
6. After installing the front passenger's weight
sensors unit, confirm proper system operation:
Turn the ignition switch ON (II): the SRS indicator
should come on for about 6 seconds and then go
off.
A
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
23-391