Configuring Basic Test Call - AudioCodes Mediant 800B User Manual

User's Manual
Note:
•
You can configure the DTMF signaling type (e.g., out-of-band or in-band) using
the 'DTMF Transport Type' parameter. For more information, see 'Configuring
DTMF Transport Types' on page 197.
•
To generate DTMF tones, the device's DSP resources are required.
•
Instead of playing DTMF tones, the device can play a non-DTMF tone from a PRT
file (Dial Tone #2). To enable this, you must configure 'Play' to PRT in the Test
Call Rules table and load a PRT file to the device (see 'Prerecorded Tones File' on
page 780).

To configure played DTMF signal to answered test call:
1. Open the Test Call Settings page (Troubleshooting tab > Troubleshooting menu >
Test Call folder > Test Call Settings).
2. In the 'Test Call DTMF String' field, enter the DTMF string (up to 15 digits):
Figure 64-3: Configuring Played DTMF Tone for Test Calls
3. Click Apply.
64.6

Configuring Basic Test Call

The Basic Test Call feature tests incoming calls from remote SIP (IP) endpoints to a single
simulated test endpoint (Tel side) on the device. The test call is for IP-to-Tel calls (i.e.,
Gateway calls). The only required configuration is to assign a prefix number (test call ID) to
the simulated endpoint. All incoming calls with this called (destination) prefix number are
identified as a test call and sent to the simulated endpoint. The figure below displays a
basic test call example.

To configure basic call testing:
1. Open the Test Call Settings page (Troubleshooting tab > Troubleshooting menu >
Test Call folder > Test Call Settings).
Version 7.2
Figure 64-4: Incoming Test Call Example
959
64. Testing SIP Signaling Calls
Mediant 800B Gateway & E-SBC