Configuring Basic Test Call - AudioCodes Mediant 1000B User Manual


To configure the played DTMF signal to answered test call:
1. Open the Test Call Settings page (Configuration tab > System menu > Test Call >
Test Call Settings).
2. In the 'Test Call DTMF String' field, enter the DTMF string (up to 15 digits).
3. Click Submit.
56.5

Configuring Basic Test Call

The Basic Test Call feature tests incoming Gateway calls from a remote SIP endpoint to a
simulated test endpoint on the device. The only required configuration is to assign a prefix
number (test call ID) to the simulated endpoint. All incoming calls with this called
(destination) prefix number is identified as a test call and sent to the simulated endpoint.
The figure below displays a basic test call example.

To configure basic call testing:
1. Open the Test Call Settings page (Configuration tab > System menu > Test Call >
Test Call Settings).
2. In the 'Test Call ID' field, enter a prefix for the simulated endpoint.
3. Click Submit.
Notes:
•
The Basic Test Call feature tests incoming calls only and is initiated only upon
receipt of incoming calls with the configured prefix.
•
For a full description of the parameter, see 'SIP Test Call Parameters' on page
907.
•
The call test is done on all SIP Interfaces.
•
The call test is applicable only to the Gateway application.
User's Manual
Figure 56-3: DTMF in Test Call Settings Page
Figure 56-4: Incoming Test Call Example
Figure 56-5: Test Call Settings Page
868
Mediant 1000B Gateway and E- SBC
Document #: LTRT-27044