Configuring Basic Test Call - AudioCodes Mediant 3000 User Manual

User's Manual

To configure the played DTMF signal to answered test call:
1. Open the Test Call Settings page (Configuration tab > System menu > Test Call >
Test Call Settings).
2. In the 'Test Call DTMF String' field, enter the DTMF string (up to 15 digits).
3. Click Submit.
51.3

Configuring Basic Test Call

The Basic Test Call feature tests incoming Gateway / IP-to-IP calls from a remote SIP
endpoint to a simulated test endpoint on the device. The only required configuration is to
assign a prefix number (test call ID) to the simulated endpoint. All incoming calls with this
called (destination) prefix number is identified as a test call and sent to the simulated
endpoint. The figure below displays a basic test call example.

To configure basic call testing:
1. Open the Test Call Settings page (Configuration tab > System menu > Test Call >
Test Call Settings).
2. In the 'Test Call ID' field, enter a prefix for the simulated endpoint.
3. Click Submit to apply your settings.
Notes:
Version 6.6
Figure 51-3: Test Call Settings Page
Figure 51-4: Incoming Test Call Example
Figure 51-5: Test Call Settings Page
•
The Basic Test Call feature tests incoming calls only and is initiated only
upon receipt of incoming calls with the configured prefix.
•
For a full description of this parameter, see 'SIP Test Call Parameters' on
page 662.
•
This call test is done on all SIP interfaces.
•
This call test is applicable only to the Gateway/IP-to-IP application.
633
51. Testing SIP Signaling Calls
Mediant 3000