Mitsubishi Electric Q173CPU Programming Manual page 293

Q series motion controller
Hide thumbs Also See for Q173CPU:
Table of Contents

Advertisement

7 OPERATION CONTROL PROGRAMS
[Controls]
(6) By specifying a negative speed and making a speed change request during the
start, allows the axis to start deceleration at that point and return in the opposite
direction upon completion of deceleration.
The following operations by the servo instruction are shown below.
Control mode
Linear control
Circular interpolation
control
Fixed-pitch feed
Constant-speed control
Speed control (I)
Speed control (II)
Speed/position control
Position follow-up control
Speed switching control
JOG operation
High-speed oscillation
Home position return
(a) If a speed change is made to a negative speed, control is executed with the
control mode during the start as indicated in the above table.
(b) The returning command speed is the absolute value of a new speed.
(c) When the axis is waiting at the return position
1) Signal states (n : Axis No., m : Axis No. –1)
• Start accept (M2000+n)
• Positioning start completion (M2400+20m) ON
• Positioning completion (M2401+20m) OFF
• In-position (M2402+20m)
• Command in-position (M2403+20m)
• Speed change "0" accepting flag (M2240+m)
2) Make a speed change to a positive speed for a restart.
3) Turn on the stop command to end the positioning.
4) A negative speed change made again will be ignored.
Servo instruction
ABS
1
INC
1
ABS
2
INC
2
ABS
3
INC
3
ABS
4
INC
4
ABS circular
INC circular
FEED
1
FEED
2
FEED
CPSTART1
CPSTART2
CPSTART3
CPSTART4
VF
VR
VVF
VVR
VPF
VPR
VPSTART
PFSTART
VSTART
OSC
ZERO
(Note) : Minor error [301] : A speed change was made during home position return.
Minor error [305] : The setting speed is outside the range of 0 to speed limit value.
Minor error [310] : A speed change was made during high-speed oscillation.
7 - 68
Operation
On completion of deceleration, the axis
reverses its moving direction, returns to the
positioning starting point at the absolute
value of the specified speed, and stops
(waits) there.
For circular interpolation, the axis returns in
the circular path.
3
On completion of deceleration, the axis
reverses its moving direction, returns to the
preceding point at the absolute value of the
specified speed, and stops (waits) there.
On completion of deceleration, the axis
reverses its moving direction at the absolute
value of the specified speed.
The axis does not stop until a stop instruction
is input.
The axis cannot return.
The speed change request is regarded as a
normal speed change request.
(Note)
Minor error [305]
will occur and the axis
will be controlled at the speed limit value.
A speed change cannot be made. Minor
(Note)
error [310]
will occur.
A speed change cannot be made. Minor
(Note)
error [301]
will occur.
ON
(unchanged from before
execution of CHGV instruction)
(unchanged from before
execution of CHGV instruction)
ON
OFF
ON

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Q173cpunQ172cpuQ172cpun

Table of Contents