5 MOTION DEDICATED PLC INSTRUCTION
(2) S(P).SVST instruction accepting and normal/abnormal completion can be
confirmed with the complete device (D1) or status display device (D2) at the
(a) Complete device
It is turned on by the END processing of scan which the instruction
completed, and turned off by the next END processing.
(b) Status display device at the completion
It is turned on/off according to the status of the instruction completion.
Abnormal completion : It is turned on by the END processing of scan
(1) Setting of the starting axis
The starting axis set as (S1) sets J + Axis No. in a character sequence " ".
Up to 8 axes can be set. If multiple axes are set, it sets without dividing in a
The axis No. set in the system setting (Refer to Section 1.5) is used as the axis
No. to start.
And, the axis No. to start does not need to be a order.
Example) When multiple axes (Axis1, Axis2, Axis10, Axis11) are set.
(2) Setting of the servo program No.
(S2) usable range
0 to 4095
which the instruction completed, and turned off by
the next END processing.
(S1) usable range
1 to 32
1 to 8
5 - 14