Changes In The Current Manual - Siemens SINAMICS G120 Operating Instructions Manual

Changes in the current manual

Notable changes since Edition 01/2017
New hardware
● Operator Panel IOP replaced by Intelligent Operator Panel 2 (IOP-2).
● New PM240‑2 Power Modules in push-through technology, FSD ... FSF - for 200 V, 400 V
and 690 V
New functions
● Expansion of the technology controller to include the following functions:
– Gain K
– The control deviation can be used as adaptation signal.
● Improved method for optimizing the efficiency of standard induction motors
● DC Link formation with the PM330 power module
● The inverter issues an alarm if a memory card is not inserted.
Overview of all new and modified functions in firmware V4.7 SP9:
Corrections
● Default 14 of the terminal strip corrected:
The higher-level control switches the function of the terminal strip via PZD01, bit 15 (not
via digital input DI 3).
● The compound braking is not available with either the PM240‑2 power module or the
PM240P‑2 power module.
The compound braking is not available with either the PM230 power module or the PM330
power module.
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE
Tools to commission the inverter (Page 146)
Installing Power Modules (Page 64)
Power Module (Page 34)
Technical data, PM240-2 Power Module (Page 476)
and integral time T
P
PID technology controller (Page 274)
Efficiency optimization (Page 348)
Forming DC link capacitors (Page 149)
Activate message for a memory card that is not inserted (Page 380)
Firmware version 4.7 SP9 (Page 515)
Default setting of the interfaces (Page 115)
Electrically braking the motor (Page 311)
can be adapted.
N
5