Using Handsfree - NEC Electra Elite IPK II System User Manual

Document Revision 4C
U
S 3
SING
ECTION
The manual assumes each extension has Automatic Handsfree. This lets a user just
press a line key or Speaker Key to answer or place a call. For extensions without
Automatic Handsfree, the user must:


Table 3-1 Post Dialing Service Codes – Single Digit Post Dialing Codes
Code
1 Handsfree Answerback / Forced intercom Ringing
2 Department Step Calling
3~5 Not used
6 Voice Over
7 Barge-In
8 Voice Mail
0 Message Waiting
# Call Waiting / Camp-On / Callback / Trunk Queuing
Off-Hook Signaling

3 - 2
H
ANDSFREE
Lift the handset or press Speaker for intercom dial tone.
Lift the handset or press Speaker, then press a line key for trunk dial tone.
For this feature. . . When you . . .
Change the signaling mode of your outgoing Intercom
call
Cycle to the next member of a Department Calling
Group
Send a Voice Over to a busy extension after hearing
Busy/Ring tone
Barge into another station active call
Leave a message in a co-worker's mailbox after
calling their busy or unanswered extension
Leave a Message Waiting at a co-worker's busy or
unanswered extension
Use Call Waiting / Camp-On / Callback / Trunk
Queuing
Send off-hook signal tones to a busy extension
Electra Elite IPK II
Codes Tables