NEC Electra Elite IPK II System User Manual page 1010

Document Revision 4C

20-18-07 Service Tone Timers – Intrusion Tone Repeat Time
After a user barges in, the system repeats the Barge-In tone after this time (0~64800 seconds).
Normally, you should disable this time by entering 0. (This timer also affects any other type of
call interruption features, such as Voice Mail Conversation Recording or Voice Over.)
(default: 0)

21-01-03 System Options for Outgoing Calls – Trunk Interdigit Time (External)
Program the time (0~64800 seconds) an extension must wait before using the Barge-In feature
can be used on a call (this time expires before putting a call in a talk state). This time also affects
Voice Over.
(default: 5)

22-04-01 Incoming Extension Ring Group Assignment
Assign extensions to ring groups.

22-05-01 Incoming Trunk Ring Group Assignment
Define a trunk ring group. When transferring a DID or trunk call to the trunk defined ring group,
the trunk then rings the defined extensions for the ring group.
(default: 1)

22-08-01 DIL/IRG No Answer Destination
Assign the DIL No Answer Ring Group to which an unanswered call should overflow.
0 = No Setting
1~100 = Incoming Groups
102 = In-Skin/External Voice Mail
(default: 1)

24-02-01 System Options for Transfer – Busy Transfer
Prevent (0)/Allow (1) extensions to transfer calls to busy extensions. If disabled, calls
transferred to busy extensions recall immediately.
(default: 1)

24-02-03 System Options for Transfer – Delayed Call Forwarding Time
If activated at an extension, Delayed Call Forwarding occurs after this time (0~64800 seconds).
This also sets how long a Transferred call waits at an extension forwarded to Voice Mail before
routing to the called extension mailbox.
(default: 10)

24-02-04 System Options for Transfer – Transfer Recall Time
Set the Transfer Recall Time (0~64800 seconds). An unanswered transferred call recalls to the
extension that initially transferred it after this time. This time also sets how long a transferred
call camps-on to a busy extension.
(default: 30)

24-02-05 System Options for Transfer – Message Wait Ring Interval Time
After a trunk is unscreen transferred to a busy Department Group, this time (0~64800 seconds)
starts. If the call is not answered, it recalls the originator.
(default: 30)

25-06-01 VRS/DISA One-Digit Code Attendant Setup – Next Attendant Message Number
Assign the message number (0~48)
[default: 0 (No Setting)]
2 - 986
Electra Elite IPK II
Transfer