Installation - Isuzu 1999 RODEO Workshop Manual

Installation

1. Install the camshaft position sensor and tighten
timing rear cover bolt.
Torque: 8 N·m (5.9 lb ft)
2. Install the cylinder head cover and tighten bolts to the
specified torque.
Torque: 8 N·m (5.9 lb ft)
3. Install the timing belt front cover then tighten fixing
bolts to the specified torque.
Torque: 6 N·m (4.4 lb ft)
4. Install the crankshaft pulley, tighten fixing bolts to the
specified torque.
Torque: 20 N·m (14 lb ft)
ENGINE MECHANICAL (X22SE 2.2L)
5. Move drive belt tensioner to loose side using wrench
then install the drive belt to normal position.
6. Connect ignition cable to ignition plug.
7. Install ignition cable cover to cylinder head cover and
tighten two bolt to the specified torque.
020RW012
Torque: 3 N·m (2 lb ft)
8. Install intake duct bracket to cylinder block.
9. Install PCV hose flange to cylinder block to the
specified torque.
Torque: 25 N·m (18 lb ft)
020RW014
6A–17
033RW001
020RW015