Dtc P2610[L3 With Tc] - Mazda CX-7 2007 Workshop Manual

STEP
7 VERIFY TROUBLESHOOTING OF DTC P2507
COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Turn the ignition switch to the ON position
(Engine off).
• Clear the DTC from the PCM memory using
the M-MDS.
• Start the engine and warm it up completely.
• Is the same DTC present?
8 VERIFY AFTER REPAIR PROCEDURE
• Perform the "After Repair Procedure".
(See01-14-4 AFTER REPAIR
PROCEDURE[L3 WITH TC].)
• Are any DTCs present?
End Of Sie
WM: DTC P26XX

DTC P2610[L3 WITH TC]

DTC P2610 PCM internal engine off timer performance
• PCM internal engine off timer is damaged.
Diagnostic support note
• This is a continuous monitor (CCM).
• MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in
DETECTION
one drive cycle while the DTC for the same malfunction has been stored in the PCM.
CONDITION
• PENDING CODE is available if the PCM detects the above malfunction condition during the first drive
cycle.
• FREEZE FRAME DATA is available.
• DTCs are stored in the PCM memory.
POSSIBLE
• PCM internal engine off timer is damaged.
CAUSE
Diagnostic procedure
STEP
1 VERIFY FREEZE FRAME DATA HAS BEEN
RECORDED
• Has the FREEZE FRAME DATA been
recorded?
2 VERIFY RELATED REPAIR INFORMATION
AVAILABILITY
• Verify related service Bulletins and/or on-line
repair information availability.
• Is any related repair information available?
3 VERIFY TROUBLESHOOTING OF DTC P2610
COMPLETED
• Make sure to reconnect all the disconnected
connectors.
• Clear the DTC from the PCM memory using
the M-MDS.
• Start the engine.
• Is the same DTC present?
4 VERIFY AFTER REPAIR PROCEDURE
• Perform the "AFTER REPAIR PROCEDURE".
(See01-14-4 AFTER REPAIR
PROCEDURE[L3 WITH TC].)
• Are any DTCs present?
End Of Sie
01-02–258
ON-BOARD DIAGNOSTIC [L3 WITH TC]
INSPECTION
INSPECTION
Yes Replace the PCM, then go to the next step.
(See01-40-6 PCM REMOVAL/INSTALLATION[L3 WITH
TC].)
No Go to the next step.
Yes Go to the applicable DTC inspection.
(See01-02-13 DTC TABLE[L3 WITH TC].)
No Troubleshooting completed.
Yes Go to the next step.
No Record the FREEZE FRAME DATA on the repair order,
then go to the next step.
Yes Perform the repair or diagnosis according to the available
repair information.
• If the vehicle is not repaired, go to the next step.
No Go to the next step.
Yes Replace the PCM, then go to the next step.
(See01-40-6 PCM REMOVAL/INSTALLATION[L3 WITH
TC].)
No Go to the next step.
Yes Go to the applicable DTC troubleshooting.
(See01-02-13 DTC TABLE[L3 WITH TC].)
No DTC troubleshooting completed.
ACTION
id010239814400
ACTION