Modifying The Default Ip Network Service - Polycom RealPresence 800s Administrator's Manual

Modifying the Default IP Network Service

The Default IP Service parameters need to be modified if you want to change the:
•
•
•
•
•
Fast Configuration Wizard
The Fast Configuration Wizard enables you to configure the Default IP Service. It starts
automatically if no Default IP Network Service is defined. This happens during First Time
Power-up, before the service has been defined or if the Default IP Service has been deleted,
followed by an Collaboration Server restart.
The IP Management Service tab in the Fast Configuration Wizard is enabled only if the factory
default Management IP addresses were not modified.
If the Fast Configuration Wizard does not start automatically, the Default IP Service must be
modified through the IP Network Properties dialog boxes.
To view or modify the Default IP Service:
1
2
Polycom, Inc.
Network type that the Collaboration Server connects to
IP address of the Collaboration Server Signaling Host
Subnet mask of the Collaboration Server's IP cards
Gatekeeper parameters or add gatekeepers to the Alternate Gatekeepers list
SIP server parameters
In the Collaboration Server Management pane, click IP Network Services (
In the Network list pane, double-click the Default IP Service (
The Default IP Service - Networking IP dialog box opens.
Chapter 16-IP Network Services
).
, , or ) entry.
16-9