Polycom RealPresence 800s Administrator's Manual page 515

Collaboration server
Hide thumbs Also See for RealPresence 800s:
Table of Contents

Advertisement

Polycom, Inc.
Table 21-2
Manually Added System Flags – MCMS_PARAMETERS (Continued)
Flag
CP_REGARD_TO_INCOMIN
G_SETUP_RATE
CPU_BONDING_LINK_MON
ITORING_FREQUENCY
CPU_BONDING_MODE
DISABLE_CELLS_NETWOR
K_IND
DISABLE_DUMMY_REGIST
RATION
Description
For use in the Avaya Environment.
If set to YES, the Collaboration Server calculates the line rate
for incoming calls in CP conferences, according to the line
rate which is declared by the endpoint in the H.225 setup
message.
If set to NO, the rate is calculated according to the conference
line rate regardless of the rate in the H.225 setup message.
Default: YES.
Used when using the MII Monitor for troubleshooting
networks.This flag sets the MII Polling Interval in milliseconds.
A value of zero disables MII monitoring.
Default: 100
Sets the Bonding Mode of the Signalling and Management
network interface controllers.
Mode=6, balance-alb,
(Adaptive Load Balancing) includes balance-tlb, (Transmit
Load Balancing) and balance-rlb (Receive Load Balancing)
for IPV4 traffic. No special switch support is required.
Receive Load Balancing is achieved by ARP negotiation.
Outbound ARP Replies are intercepted and their source
hardware address is overwritten with the unique hardware
address of one of the slaves in the bond. In this way different
peers will use different hardware addresses for the server.
Note: balance-alb is the only supported value. All other
possible values are for troubleshooting purposes only.
Default: balance-alb
Possible values:
balance-alb
balance-rr
active-backup
balance-xor
broadcast
802.3ad
balance-tlb
Disable the display of Network Quality Indicators displayed in
the cells of the conference Video Layout.
Default: YES
Range: YES / NO
Enables or disables SIP dummy registration on the domain.
Possible Values:
NO (Default) - Disables SIP dummy registration.
YES - Enables SIP dummy registration.
Note: For homologation and certification testing, the flag must
be set to YES.
Chapter 21-System Configuration Flags
21-15

Advertisement

Table of Contents
loading

Table of Contents