Polycom RealPresence 800s Administrator's Manual page 521

Polycom, Inc.
Table 21-2 Manually Added System Flags – MCMS_PARAMETERS (Continued)
Flag
H323_FREE_VIDEO_RESO
URCES
HIDE_CONFERENCE_PASS
WORD
IP_LINK_ENVIRONMENT
IP_RESPONSE_ECHO
ITP_CERTIFICATION
LAN_REDUNDANCY
Description
For use in the Avaya Environment.
In the Avaya Environment there are features that involve
converting undefined dial-in participants' connections from
video to audio (or vice versa). To ensure that the participants'
video resources remain available for them, and are not
released for use by Audio Only calls, set this flag to NO.
If set to YES, the Collaboration Server will release video
resources for Audio Only calls.
Default: YES.
If set to YES:
•
Conference and Chairperson Passwords that are
displayed in the Collaboration Server Web Client or RMX
Manager are hidden when viewing the properties of the
conference.
•
Automatic generation of passwords (both conference and
chairperson passwords) is disabled, regardless of the
settings of the flags:
•
NUMERIC_CONF_PASS_DEFAULT _LEN
•
NUMERIC_CHAIR_PASS_ DEFAULT_LEN.
For more information see "Automatic Password Generation
Flags" on page 21-34
Default: NO.
In H.239-enabled MIH Cascading, when MGC is on level 1,
setting this flag to YES will adjust the line rate of HD Video
Switching conferences run on the RealPresence
Collaboration Server 800s from 1920Kbps to 18432, 100bits/
sec to match the actual rate of the IP Only HD Video
Switching conference running on the MGC.
Note: If the flag MIX_LINK_ENVIRONMENT is set to NO, the
IP_ENVIRONMENT_LINK flag must be set to YES.
When the System Flag value is YES, the Collaboration Server
will respond to ping (IPv4) commands. When set to NO, the
Collaboration Server will not respond to ping commands.
When set to NO (default), this flag disables the telepresence
features in the Conference Profile.
Set the flag to YES to enable the telepresence features in the
Conference Profile (provided that the appropriate License is
installed).
Enables Local Area Network port redundancy.
Default: NO
Range: YES / NO
Note: If the flag value is set to YES and either of the LAN
connections (LAN1 or LAN2) experiences a problem, an
active alarm is raised stating that there is no LAN connection,
specifying both the card and port number.
Chapter 21-System Configuration Flags
21-21