Polycom RealPresence 800s Administrator's Manual page 558

RealPresence Collaboration Server 800s Administrator's Guide
Table B-1 Active Alarms (Continued)
Alarm Code
Hot Backup: Paired MCU is unreachable.
Initialization of ice stack failed
Insufficient resources
Insufficient UDP Ports
Internal System configuration during
startup
Invalid System Configuration
IP addresses of Signaling Host and
Control Unit are the same
IP Network Service added
IP Network Service configuration modified
IP Network Service deleted
IP Network Service not found
IPMC software upgrade in component
IPS 140 test result not received
LDAP TLS: Failed to connect to OSCP
responder
License not found
Management Network not configured
Missing Central Signaling configuration
Missing Central Signaling IP configuration
B-6
Alarm Description
The number of resources in the license is higher than the actual system
resources.
Check the media cards or insert a media card.
When defining fixed port, the number of defined UDP ports is lower than the
required ports.
Configure additional ports.
System configuration during startup.
Wait until Collaboration Server startup is completed.
IP addresses of Signaling Host and Control Unit are identical.
Assign different IP addresses to the Signaling Host and Control Unit.
IP Network Service was modified.
Reset the MCU.
IP Network Service was deleted.
Reset the MCU.
IP Service not found in the Network Services list.
Configure the IP Network Service.
Possible causes:
•
The Central Signaling component could not find the IP Services after
startup.
•
During Startup, the resources did not get the License required to utilize
their Units.
Possible action:
•
Configure IP service if not configure.
•
Reset the MCU.
•
Change the license
Configure the Management Network.
Configure the central signaling.
Polycom, Inc.