Polycom RealPresence 800s Administrator's Manual page 42

Polycom® RealPresence Collaboration Server 800s Administrator's Guide
2-22
Table 2-9 New AVC CP Profile - Advanced Parameters (Continued)
Field/Option
Auto Terminate
Auto Redialing
Exclusive Content
Mode
Enable FECC
FW NAT Keep Alive
Interval
Description
When selected (default), the conference automatically ends when the
termination conditions are met:
Before First Joins — No participant has connected to a conference
during the n minutes after it started. Default idle time is 10 minutes.
At the End - After Last Quits — All the participants have
disconnected from the conference and the conference is idle (empty)
for the predefined time period. Default idle time is 1 minute.
At the End - When Last Participant Remains — Only one
participant is still connected to the conference for the predefined time
period (excluding the recording link which is not considered a
participant when this option is selected).
Note: The selection of this option is automatically cleared and
disabled when the Operator Conference option is selected. The
Operator conference cannot automatically end unless it is terminated
by the Collaboration Server User.
The Auto Redialing option instructs the Collaboration Server to
automatically redial H.323 and SIP participants that have been
abnormally disconnected from the conference.
•
Auto Redialing is disabled by default.
•
Auto Redialing can be enabled or disabled during an ongoing
conference using the Conference Properties – Advanced dialog
box.
•
The Collaboration Server will not redial an endpoint that has been
disconnected from the conference by the participant.
•
The Collaboration Server will not redial an endpoint that has been
disconnected or deleted from the conference by an operator or
administrator.
Select the Exclusive Content Mode check box to limit the Content
broadcasting to one participant, preventing other participants from
interrupting the Content broadcasting while it is active. For more
details, see "an additional resourceis" on page 3-19.
This option is enabled by default, allowing participants in the
conference to control the zoom and PAN of other endpoints in the
conference via the FECC channel. Clear this check box to disable
this option for all conference participants.
The MCU can be configured to send a FW NAT Keep Alive message
at specific Intervals for the RTP, UDP and BFCP channels.
For more information see "FW (Firewall) NAT Keep Alive" on
page 16-76.
If needed, modify the NAT Keep Alive Interval field within the range of
1 - 86400 seconds.For more information see "FW (Firewall) NAT
Keep Alive" on page 16-76.
Polycom, Inc.