Neighbor; Network - Dell Force10 S4810P Reference Manual

neighbor

Define a neighbor router with which to exchange RIP information.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax neighbor ip-address
To delete a neighbor setting, use the no neighbor ip-address command.
Parameters
ip-address
Defaults Not configured.
Command Modes ROUTER RIP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Usage
When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor routers
Information
are possible.
Use the passive-interface command in conjunction with the neighbor command to
ensure that only specific interfaces are receiving and sending data.
Related passive-interface
Commands

network

Enable RIP for a specified network. Use this command to enable RIP on all networks connected to the switch.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax network ip-address
To disable RIP for a network, use the no network ip-address command.
Parameters
ip-address
1364
Enter the IP address, in dotted decimal format, of a router with which
to exchange information.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– sets the interface to only listen to RIP broadcasts.
Specify an IP network address in dotted decimal format. You cannot
specify a subnet.