Ip Prefix-List - Dell Force10 S4810P Reference Manual

Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage
Sequence numbers for this filter are automatically assigned starting at sequence number 5.
Information
If you do not use the ge or le options, only packets with an exact match to the prefix are
filtered.
Related
permit
Commands
seq

ip prefix-list

Enter the PREFIX-LIST mode and configure a prefix list.
C-Series, E-Series, S-Series, Z-Series
Syntax ip prefix-list prefix-name
To delete a prefix list, use the no ip prefix-list prefix-name command.
Parameters
prefix-name
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage Prefix lists redistribute OSPF and RIP routes meeting specific criteria. For related RIP
Information commands supported on C-Series and E-Series, refer to
related OSPF commands supported on all three platforms, refer to the Open Shortest Path First
(OSPFv2 and OSPFv3) section in the
Related
show ip route list
Commands
show ip prefix-list summary
300
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– configures a filter to pass packets.
– configures a drop or permit filter with a specified sequence number.
Enter a string up to 16 characters long as the name of the prefix list,
up to 140 characters long.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– displays IP routes in an IP prefix list.
– displays a summary of the configured prefix lists.
Routing Information Protocol
E-Series FTOS Command Line Reference Guide .
(RIP). For