Dell Force10 S4810P Reference Manual page 293

Parameters
any
host
address
mac-source-
address
mac-source-
address-mask
mac-destination-
address
mac-destination-
address-mask
ethertype
operator
count
byte
log
monitor
Defaults Not configured.
Command Modes CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
• Use the no deny {any | host mac-address | mac-source-address
mac-source-address-mask} {any | host mac-address | mac-
destination-address mac-destination-address-mask} command.
Enter the keyword any to drop all packets.
mac-
Enter the keyword host and then enter a MAC address to drop
packets with that host address.
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
Specify which bits in the MAC address must match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
Enter the destination MAC address and mask in nn:nn:nn:nn:nn:nn
format.
Specify which bits in the MAC address must match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
(OPTIONAL) To filter based on protocol type, enter one of the
following Ethertypes:
•
•
•
(OPTIONAL) Enter the keyword count to count packets processed
by the filter.
(OPTIONAL) Enter the keyword byte to count bytes processed by
the filter.
(OPTIONAL, E-Series only) Enter the keyword log to log the packets.
(OPTIONAL) Enter the keyword monitor when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface. For more
information, refer to the "Flow-based Monitoring" section in the Port
Monitoring chapter of the
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
ev2 - is the Ethernet II frame format
llc - is the IEEE 802.3 frame format
snap - is the IEEE 802.3 SNAP frame format
FTOS Configuration Guide .
293