Configure Log Filter Set Severity - Extreme Networks ExtremeWare Command Reference Manual

Commands for Status Monitoring and Statistics

configure log filter set severity

configure log filter <filter name> set severity <severity> events
[<event component> | all ]
Description
Sets the severity level of an existing filter item.
Syntax Description
filter name Specifies the filter to configure.
severity Specifies the severity level to send.
event component Specifies all the events associated with a particular component.
Default
N/A
Usage Guidelines
This command modifies the severity level of an existing filter item describing a particular set of events.
Using this command is equivalent to deleting the filter item from the filter and then adding back a filter
item describing the same set of events with a different severity level. The command can only be used to
modify a filter item referring to a set of events with a severity level, as opposed to one that makes use
of only a single severity. It can be used to modify either "exclude" or "include" filter items.
For example, to change the severity level of the filter item added with this command:
configure log filter bgpFilter2 add events bgp.keepalive severity notice
use the following command:
configure log filter bgpFilter2 set severity info events bgp.keepalive
Using this single command is preferred to using a
configure log filter bgpFilter2 delete events bgp.keepalive
configure log filter bgpFilter2 add events bgp.keepalive severity info
Using the single command eliminates the possibility of missing an event of interest between the
separate and
delete add
Note that the severity of a filter item configured to include or exclude incidents based on event
parameter values (for example slot number) can also be modified using the
command on page 684.
set severity match
See the command on page 775 for a detailed description of severity levels.
show log
To see the current configuration of a target, use the following command:
show log configuration target
682
commands.
command followed by an
delete
command:
add
configure log filter
ExtremeWare 7.5 Command Reference Guide