Enable Ip-Subnet-Lookup - Extreme Networks ExtremeWare Command Reference Manual

enable ip-subnet-lookup

enable ip-subnet-lookup
Description
Enables IPDA SUBNET lookup feature in a switch.
Syntax Description
There are no arguments or variables for this command.
Default
Default is disabled.
Usage Guidelines
For a new setting to be effective, system rebooting is needed. If IPDA SUBNET lookup is enabled for
the first time, IPDA SUBNET lookup mask length is 24 (255.255.255.0).
Example
enable ip-subnet-lookup
To be effective, system rebooting is needed
# show ipc
IP Routing : Enabled
.....
MPLS : Disabled
IP-SUBNET-Lookup : Run-Time[Disabled:
In default status, IPDA SUBNET lookup feature is disabled.
# show ipc
IP Routing : Enabled
.....
MPLS : Disabled
IP-SUBNET-Lookup : Run-Time[Disabled:
If flow redirections, IPDA QOS, or FDB ACL is configured, operation is aborted with
error message
# enable ip-subnet-lookup
ERROR: Flow Redirection is already configured. Remove flow redirection configuration
at first.
History
This command was first available in ExtremeWare 7.3
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.3.0 Command Reference Guide
0] Config[Enabled: 24]
0] Config[Disabled: 0]
enable ip-subnet-lookup
899