Extreme Networks ExtremeWare Command Reference Manual page 714

Hide thumbs Also See for ExtremeWare:

Table of Contents

Commands for Status Monitoring and Statistics

For ExtremeWare 6.1, the system always reboots after a task exception when the system recovery level is

specified as

For ExtremeWare 6.2 or later, you must specify whether the system should shut down or reboot upon a

task exception if the recovery level is

For BlackDiamond Switches. For ExtremeWare 6.2.2 or later, if

BlackDiamond switch and there is a software exception on the master MSM, the interrupt handler

triggers the slave MSM to take over control of the switch.

The following command configures a switch to reboot after a critical task exception occurs:

configure sys-recovery-level critical reboot

The following command configures the Master MSM to failover to the Slave MSM if a software

exception occurs:

configure sys-recovery-level critical msm-failover

This command was first available in ExtremeWare 6.1.

Modified in ExtremeWare 6.2 to support the

Modified in ExtremeWare 6.2.2 to support the

This command was added to the Summit "e" series of switches in ExtremeWare 7.1e.

Modified in ExtremeWare 7.2e to support the

Platform Availability

This command is available on all i-series switches. The

BlackDiamond switch only.

msm-failover

msm-failover

option is available on the

msm-failover

is specified on a

ExtremeWare 7.5 Command Reference Guide

Extremeware 7.5