Table of Contents
Advertisement
Related
Documentation
Configuring Routing Engine Redundancy (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Table 12: Chassis Alarms Configuration Details
Task
Configuring the alarm type.
Configuring Aggregated Devices (NSM Procedure) on page 11
Configuring Chassis FPC (NSM Procedure)
Configuring Routing Engine Redundancy (NSM Procedure) on page 13
You can configure redundancy properties for routers that have multiple Routing Engines
or these multiple switching control boards: Switching and Forwarding Modules (SFMs),
System and Switch Boards (SSBs), Forwarding Engine Boards (FEBs), or Compact
Forwarding Engine Boards (CFEBs).
To configure routing engine redundancy in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, select Chassis > Redundancy.
3.
Add or modify settings as specified in Table 13 on page 13.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 13: Chassis Redundancy Configuration Details
Task
Configure redundancy
options.
Instruct the backup router to
take mastership if it detects
hard disk errors or a loss of a
keepalive signal from the
master Routing Engine.
Your Action
1.
Select the interface type listed next to Alarm.
2. Select the alarm type for the chassis condition for each
interface type.
Your Action
1.
In the Comment box, enter the comment.
2. From the keepalive list, select the time before the backup
router takes mastership when it detects loss of the keepalive
signal.
Range: 2 through 10,000
1.
Click Failover next to Redundancy.
2. In the Comment box, enter the comment.
3. Select the type of failover.
Chapter 2: Configuring Chassis
13
Advertisement
Table of Contents
