Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1433

update-source
For OSPF:
Syntax
[ no ] update-source loopback interfaceSpecifier
For PIM:
update-source interfaceType interfaceSpecifier
no update-source [ interfaceType interfaceSpecifier ]
For RIP:
[ no ] update-source interfaceType interfaceSpecifier
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the loopback interface whose local address is used as the source address
Description
for the OSPF, PIM, or RIP connection to a remote neighbor. The no version deletes
the source address from the connection.
NOTE: For PIM, this command is typically used when you configure PIM remote
neighbors to run multicast services over BGP/MPLS VPNs. That functionality is no
longer supported.
Options
Remote Neighbor Configuration
Mode
interfaceSpecifier Integer, in the range 1–4294967293, identifying the loopback
interface
interfaceType Interface type; see Interface Types and Specifiers on page 5
interfaceSpecifier Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
Chapter 9: U, V, W, and Y Commands
update-source
1391