Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1407

tunnel peer-identity
tunnel peer-identity { address ipAddress | subnet ipAddress subnetMask |
Syntax
range ipAddressLow ipAddressHigh }
no tunnel peer-identity
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the peer identity of the IPSec tunnel. The no version removes the peer
Description
endpoint.
Options
Interface Configuration
Mode
ipAddress IP address of the peer identity
subnetMask Mask applied to the subnet IP address of the peer identity
ipAddressLow Lower bound of the range of IP addresses of the peer identity
ipAddressHigh Upper bound of the range of IP addresses of the peer identity
Chapter 8: T Commands
1365
tunnel peer-identity