Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1383

configured. If you specify the destination address, it must be the address of the MPLS
interface or the router ID of the destination router. The no version deletes the
endpoints.
ipAddress1 IP address of the interface on the remote router
Options
hostname Name of the host to serve as the tunnel endpoint
ipAddress2 IP address of the tunnel destination address subnet
mask IP mask of the tunnel destination address subnet
ipAddressLow First IP address in a destination address range
ipAddressHigh Last IP address in a destination address range
ipAddress3 IP address of the interface on the remote router or the router ID of
the destination router that serves as the tunnel endpoint
fqdn Fully qualified domain name of the interface on the remote router that
serves as the tunnel endpoint; a maximum of 80 characters
isis-level-2 Specifies IS-IS level-2 routers as acceptable destinations
ospf-bdr Specifies OSPF border routers as acceptable destinations
listName Name of access list or prefix list that contains the IP addresses that
are acceptable as tunnel endpoints
ipAddress4 IP address of the interface on the remote router or the router ID of
the destination router that serves as the tunnel endpoint; for a tunnel profile,
you can list multiple addresses
* Indicates that one or more parameters can be repeated multiple times in a
list in the command line
Interface Configuration, IP Tunnel Destination Profile Configuration, Tunnel Profile
Mode
Configuration
Chapter 8: T Commands
1341
tunnel destination