Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1283

suspicious-control-flow-detection protocol low-threshold
suspicious-control-flow-detection protocol protocolValue
Syntax
low-threshold lowThresholdValue
no suspicious-control-flow-detection protocol protocolValue low-threshold
Command introduced in JUNOSe Release 7.3.0.
Release Information
Sets the low threshold rate at which a suspicious flow becomes no longer suspicious
Description
for a specific protocol. The no version restores the default for a protocol, which is a
protocol-dependent non-zero numeric value.
Options
Global Configuration
Mode
protocolValue Name of the protocol
lowThresholdValue Threshold value in packets per second; 0 or a number in
the range 1–32767; a value of zero means that a suspicious flow cannot change
to the nonsuspicious state via a threshold; a flow can only become nonsuspicious
via a backoff time; if the low threshold value is zero and the backoff time is zero,
the flow can only be considered nonsuspicious if the rate (in packets per second)
goes to zero
suspicious-control-flow-detection protocol low-threshold
Chapter 7: S Commands
1241