Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1370

JUNOSe 11.1.x Command Reference Guide N to Z
transform
transform transform0
Syntax
[ transform1 [ transform2 [ transform3 [ transform4 [ transform5 ] ] ] ] ]
no transform
Command introduced in JUNOSe Release 7.3.0.
Release Information
Specifies the eligible transforms for this profile for IPSec source address negotiations.
Description
You can specify up to six transform algorithms for this profile. The no version resets
the transform to the default, esp-3des-sha1.
Options
IPSec Tunnel Profile Configuration
Mode
1328
transform
transform0 through transform5 AH or ESP transform