Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1382

JUNOSe 11.1.x Command Reference Guide N to Z
tunnel destination
For DVMRP and GRE in Interface Configuration mode:
Syntax
tunnel destination { ipAddress1 | hostname }
no tunnel destination
For DVMRP and GRE in IP Tunnel Destination Profile Configuration mode:
tunnel destination { subnet ipAddress2 mask | range ipAddressLow ipAddressHigh }
For IPSec:
tunnel destination { ipAddress3 | identity fqdn }
no tunnel destination
For MPLS in Interface Configuration mode:
tunnel destination ipAddress4
no tunnel destination
For MPLS in Tunnel Profile Configuration mode:
[ no ] tunnel destination
{ { isis-level-2 | ospf-bdr } [ { access-list | prefix-list } listName ] |
{ ipAddress [ ipAddress4 ]* }
Command introduced before JUNOSe Release 7.1.0.
Release Information
IP Tunnel Destination Profile Configuration mode added in JUNOSe Release 8.2.0.
For DVMRP or GRE in Interface Configuration mode, configures the tunnel endpoint
Description
for static tunnels. The no version deletes the endpoint.
For DVMRP or GRE in IP Tunnel Destination Profile Configuration mode, configures
the tunnel endpoint for dynamic tunnels. The no version deletes the endpoint.
For IPSec, configures the remote tunnel endpoint. You can identify the remote peer
by either IP address or fully qualified domain name (FQDN). The no version deletes
the endpoint.
For MPLS in Interface Configuration mode, configures the tunnel endpoint for static
MPLS tunnels. The no version deletes the endpoint.
For MPLS in Tunnel Profile Configuration mode, configures the source of tunnel
endpoints (destinations) within a tunnel profile. You can specify that the endpoints
are to be learned from IS-IS or OSPF so that tunnels are created when the destinations
are learned from the specified IGP, or you can provide one or more IP addresses as
the endpoint(s) so that tunnels are created as soon as the destination addresses are
1340
tunnel destination