Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1420

JUNOSe 11.1.x Command Reference Guide N to Z
ubr
ubr [ pcr ]
Syntax
no ubr
Command introduced in JUNOSe Release 7.1.0.
Release Information
ATM VC Class Configuration mode added in JUNOSe Release 7.3.0.
In ATM VC Configuration mode, configures the unspecified bit rate (UBR) service
Description
category on an ATM PVC. Optionally, you can specify a peak cell rate (PCR). The ubr
command is valid only for data PVCs; you cannot use this command for control (ILMI
or signaling) PVCs. The no version restores the default service category, UBR without
a PCR.
In ATM VC Class Configuration mode, configures the UBR service category as part
of a VC class definition that you assign to an ATM data PVC. The no version restores
the default service category, UBR without a PCR, in the VC class.
Options
ATM VC Configuration, ATM VC Class Configuration
Mode
1378
ubr
pcr Peak cell rate, in Kbps, in the range 0–149760 (for OC3 ATM modules) or
0–599040 (for OC12 ATM modules)