Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1417

tx-connect-speed-method
tx-connect-speed-method { static-layer2 | dynamic-layer2 | qos | actual }
Syntax
no tx-connect-speed-method
Command introduced in JUNOSe Release 8.0.0.
Release Information
Configures for an AAA domain map (when used from Domain Map Tunnel
Description
Configuration mode) or for an AAA tunnel group (when used from Tunnel Group
Tunnel Configuration mode) the method used to calculate the transmit connect speed
of the subscriber's access interface for establishing a tunneled L2TP session. This
speed is reported in L2TP Transmit (TX) Speed AVP 24. The no version removes
configuration of the transmit connect speed calculation method from the AAA domain
map or AAA tunnel group.
Options
Domain Map Tunnel Configuration, Tunnel Group Tunnel Configuration
Mode
static-layer2 Calculates the transmit connect speed of the subscriber's access
interface based on statically configured settings for the underlying layer 2
interface
dynamic-layer2 Calculates the transmit connect speed of the subscriber's access
interface based on dynamically configured settings for the underlying layer 2
interface
qos Calculates the transmit connect speed of the subscriber's access interface
based on settings determined by QoS
actual Calculates the transmit connect speed of the subscriber's access interface
as the lesser of the dynamic-layer2 value or the qos value
Chapter 8: T Commands
tx-connect-speed-method
1375