Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1377

Chapter 8: T Commands
trigger delay
trigger delay msec delayTime
Syntax
no trigger delay
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the time duration used to determine when a SONET/SDH defect at the line
Description
or section layer becomes an alarm. The no version restores the default setting, 2500
milliseconds.
delayTime Time in the range 0–2500 milliseconds
Options
Controller Configuration
Mode
1335
trigger delay