Table of Contents
Advertisement
transmit-delay
transmit-delay transmDelay
Syntax
no transmit-delay
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets the estimated time it takes to transmit a link-state update packet on the OSPF
Description
remote-neighbor interface. The no version restores the default value.
Options
Remote Neighbor Configuration
Mode
transmDelay Link-state transmit delay in seconds; a number in the range
0–3600; default value is 1
Chapter 8: T Commands
1331
transmit-delay
Advertisement
Table of Contents
Related Manuals for Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010
Related Products for Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010
- Juniper IDP OS 5.1R1 - S REV 1
- Juniper IGP - CONFIGURATION GUIDE V11.1.X
- Juniper IP - CONFIGURATION GUIDE V11.1.X
- Juniper IP SERVICES - CONFIGURATION GUIDE V 11.1.X
- Juniper IPV6 - CONFIGURATION GUIDE V11.1.X
- Juniper JUNOS
- Juniper JUNOS - NETWORK OPERATION GUIDE REV1
- Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010
Need help?
Do you have a question about the JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 and is the answer not in the manual?