Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1291

synchronize
To force the NVS file system of the redundant SRP module to synchronize with the
Syntax
NVS file system of the primary SRP module:
synchronize
To force the system to validate all NVS files or only configuration files, and to
synchronize all files that failed the checksum test as well as any other unsynchronized
files:
synchronize low-level-check { all | configuration }
Command introduced before JUNOSe Release 7.1.0.
Release Information
Forces the NVS file system of the redundant SRP module to synchronize with the
Description
NVS file system of the primary SRP module. Optionally, you can use the
low-level-check keyword to force the system to validate all files or only configuration
files in NVS, and to synchronize all files that failed the checksum validation test during
the flash-disk compare command as well as any other files that are unsynchronized.
There is no no version.
Options
Privileged Exec
Mode
all Validates all files in NVS, and synchronizes all files that failed the checksum
test as well as any other unsynchronized files; this option can take several minutes
to complete
configuration Validates all configuration files in NVS, and synchronizes all files
that failed the checksum test as well as any other unsynchronized files; this
option takes less time to complete because it validates only a subset of the files
in the NVS file system
Chapter 7: S Commands
1249
synchronize