Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1416

JUNOSe 11.1.x Command Reference Guide N to Z
tunnel transform-set
[ no ] tunnel transform-set transformSetName
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies a transform set that ISAKMP uses during SA negotiations on this tunnel.
Description
Transform sets used for manually configured tunnels can have only one transform.
The no version removes the transform set from a tunnel.
Options
Interface Configuration
Mode
1374
tunnel transform-set
transformSetName Name of the transform set