Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1275

subscriber-interface-type
subscriber-interface-type subscriberInterfaceType
Syntax
no subscriber-interface-type { subscriberInterfaceType | all }
Command introduced in JUNOSe Release 7.1.0.
Release Information
Assigns a subscriber-interface type to a QoS parameter definition. Subscriber-interface
Description
types represent subscriber interfaces to which QoS clients can apply QoS parameter
instances obtained through RADIUS, SRC, or QoS profiles. You can specify up to four
subscriber-interface types for each parameter definition. The no version removes
the subscriber-interface type from the parameter definition.
Options
QoS Parameter Definition
Mode
Related Topics
subscriberInterfaceType One of the following subscriber-interface types: atm-vc,
ip, ipv6, l2tp-session, vlan
all Removes all subscriber-interface types
Configuring a Basic Parameter Definition for QoS Administrators
Chapter 7: S Commands
subscriber-interface-type
1233