Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1254

JUNOSe 11.1.x Command Reference Guide N to Z
speed
For console sessions:
Syntax
speed baudRate
no speed
For Ethernet interfaces on line modules:
speed speedValue
no speed
Command introduced before JUNOSe Release 7.1.0.
Release Information
When used from Line Configuration mode, sets the speed for the current and all new
Description
console sessions immediately. The no version reverts to the default value, 9600 bps.
When used from Interface Configuration mode, specifies the line speed for an Ethernet
interface. This command works with the duplex command; if you set or accept the
automatically negotiate setting for either duplex mode or speed, the router negotiates
both parameters with the remote device. The no version specifies the default,
automatically negotiate or 100 Mbps (FE-8 SFP I/O module only). This command is
not available for the Ethernet interface on the SRP module.
Options
Interface Configuration, Line Configuration
Mode
1212
speed
baudRate Terminal speed for the current console session; one of the following
values: 2400, 4800, 9600, 14400, 19200, 28800, 38400, 57600, 115200
speedValue Line speed; one of the following values:
automatically negotiate Specifies that the router negotiates the line speed
with the remote device; not valid for the FE-8 SFP I/O module
10 Specifies that the router uses a line speed of 10 Mbps on a Fast Ethernet
interface; not valid for Gigabit Ethernet interfaces or the FE-8 SFP I/O module
100 Specifies that the router uses a line speed of 100 Mbps on a
Fast Ethernet interface; not valid for Gigabit Ethernet interfaces
1000 Specifies that the router uses a line speed of 1000 Mbps on a
Gigabit Ethernet interface; not valid for Fast Ethernet interfaces