Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1300

JUNOSe 11.1.x Command Reference Guide N to Z
t1 fdl transmit
t1 channel fdl transmit { path-id | idle-signal | test-signal }
Syntax
no t1 channel fdl transmit [ path-id | idle-signal | test-signal ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Configures the router to send the specified FDL message on a T1 channel on a CT3
Description
interface. The no version stops the router from sending the specified FDL message
or all FDL messages.
Options
Controller Configuration
Mode
1258
t1 fdl transmit
channel One or more individual T1 channels, ranges of T1 channels, or
combination of individual channels and ranges, in the range 1–28 (no spaces);
for example, 3,7-15,19-13,27
path-id Transmits a path identification message every second; default value is
disabled
idle-signal Transmits an idle signal message every second; default value is
disabled
test-signal Transmits a test signal message every second; default value is
disabled